Cleaning and care
Automatic rinsing
The automatic rinse function clears
the steam generator of mineral depos-
its from the evaporated water.
After approx. 3 litres of water have been
passed through the system, the rinse
process will start automatically the next
time the steam ironing system is
switched on.
The rinsing process takes several
minutes. Steam escapes and splashing
noises can be heard. At the same time,
the message
Appliance rinsing
shown in the display on the tower.
The iron cannot be used while the
rinsing process is in progress.
The steam ironing system can only
be used again once the automatic
rinsing process is completed.
Preparing for the rinsing process
Set the steam ironing system to its
highest working position to enable
the residual water drawer to be re-
moved later on (see "Height adjust-
ment").
If the message
pears in the display, fill the water
container (see "Filling the water con-
tainer").
48
will be
ap-
Fill water cont.
Emptying the residual water drawer
After the rinsing process has com-
pleted, the residual water drawer must
be emptied. The message
drawer
will appear in the display on the
control panel when the residual water
drawer needs to be emptied. The re-
sidual water drawer can be removed
from the tower when the steam ironing
system is set at its highest working
level.
Only remove the residual water
drawer from the tower when promp-
ted to do so by the message
Empty drawer
The residual water drawer may still
be warm after the rinsing process.
Empty the residual water drawer.
As long as the residual water drawer is
not inserted into the tower, the display
will show the following message
drawer
.
Clean and dry the residual water
drawer.
Empty
in the display.
Fit