Avtech Room Alert 32E User Manual page 43

Device ManageR Push Configuration
Settings
Navigate to
for the unit to push to Device ManageR.
By default, Device ManageR queries your Room Alert for sensor values at defined intervals.
However, you may configure your Room Alert to proactively send sensor updates to Device
ManageR by enabling "Device ManageR Push."
Enabling Device ManageR Push is an advantage for two reasons:
Your Room Alert can communicate with Device ManageR from a remote network
•
without requiring complex firewall rules on the remote network. Firewalls typically
allow outgoing connections while blocking incoming connections.
Your Room Alert can immediately send an update to Device ManageR when it detects
•
an alarm, regardless of any intervals you have configured either in this section or in
the Device ManageR discovery interval.
To enable Push to Device ManageR from your Room Alert:
Enable
1. Select
2. In Server IP Address, enter the IP address of Device ManageR's host system.
3. In Server Port, enter the port Device ManageR uses. The default is 8080.
4. In Push Interval, choose the number of minutes you would like between pushes when no
alarms are detected.
5. Select Save Settings
automatically reboot and commit your changes.
Room Alert User's Guide
Advanced Device ManageR Configuration
 
Push.
at the top or bottom of the page. Your Room Alert will
to configure settings
41