Exhaust Temperature Sensor - Subaru forester 2001 Service Manual

Fuel Injection (Fuel Systems)
17. Exhaust Temperature
Sensor
S185763
A: REMOVAL
S185763A18
1) Disconnect battery ground cable.
2) Remove joint pipe.
TURBO)-13, REMOVAL, Joint Pipe.>
3) Apply SUBARU CRC or its equivalent to
threaded portion of exhaust temperature sensor,
and leave it for one minute or more.
SUBARU CRC (Part No. 004301003)
4) Remove exhaust temperature sensor.
CAUTION:
When removing the oxygen sensor, wait until
exhaust pipe cools, otherwise it will damage
exhaust pipe.

EXHAUST TEMPERATURE SENSOR

G6M0095
<Ref. to EX(DOHC
EN0836
FU(DOHC TURBO)-46
B: INSTALLATION
1) Before installing exhaust temperature sensor,
apply anti-seize compound only to threaded por-
tion of rear oxygen sensor to make the next
removal easier.
CAUTION:
Never apply anti-seize compound to protector
of exhaust temperature sensor.
Anti-seize compound:
SS-30 by JET LUBE
2) Install exhaust temperature sensor.
NOTE:
Align mark (A) on the exhaust temperature sensor
side with the joint pipe side mark (B) and tighten.
Tightening torque:
21 N·m (2.1 kgf-m, 15.2 ft-lb)
3) Install joint pipe <Ref. to EX(DOHC TURBO)-
13, INSTALLATION, Joint Pipe.>.
4) Connect battery ground cable.
S185763A11
S2M2255A
G6M0095