Service Functions - Cebora TRI STAR MIG 1636/M Instruction Manual

D C B
M
N
L
G
H
The numbers and abbreviations are shown on the display M.
Knob I. In relation to the selected LED, regulates: Welding
current, LED A, in any welding process.
wire speed (LED B), thickness (LED C) in MIG welding.
number of the MIG program or TIG or MMA welding
processes. In the service functions select the abbreviations:
For the MIG: trg, SP, HSA, CrA, PrF, PoF, Acc, bb, L, Fac
For MMA: AF, tHS.
For TIG: SLd.
Knob L.
In MIG adjusts the welding voltage, changing the arc
length. Within the "service functions" menu, based on the
abbreviation of the function set via the knob I activates
and/or adjusts it.
Display M. In all welding processes, it numerically dis-
plays the selections made via the button V and adjusted
via the knob I. For the welding current (LED A) it displays
the Amperes. For the wire speed (LED B) it displays the
meters per minute. For the thickness (LED C) it displays
the millimeters. For (LED D) it displays the set program
number. In service functions it displays the abbreviations
selected by means of knob I .
For the parameters within the service functions that are
shown on the display M, see the paragraph on service
functions.
10
A V I F
Fig. 1
Display N. In all welding processes, it displays the weld-
ing voltage; in MMA and TIG mode the open-circuit volt-
E
age, and during welding the load voltage. In MIG the pre-
set Voltage in relation to the wire speed; and the correc-
tion of the arc length set using the knob L (value between
–9.9 and 9.9; zero is the recommended value). For the
parameters in the MMA, TIG, MIG service function, that
are shown on the display N, see the paragraph on service
functions.
E - Central adapter.
This is where the welding torch is to be connected.
F – "Start" connector.
This is where the MIG torch control cable connects.
G – Negative socket.
In MMA and MIG welding with gas, the earth cable con-
nects here; in TIG and MIG welding with flux-cored wire
without gas, insert the torch power cable.
H – Positive socket
In MMA welding, connect the electrode clamp; in MIG with
gas, the power cable leaving the torch; in TIG and MIG weld-
ing with flux-cored wire without gas, the earth cable.
4 CONTROLS ON THE REAR PANEL.
Fig.2
T - Gas hose fitting.
U - Switch.
Turns the machine on and off

5 SERVICE FUNCTIONS.

Press the key V, and hold it down for at least 3 seconds
to enter the submenu. Turning the knob I selects the func-
tion, and using the knob L selects the type of operation
or the value. To return to the normal display, press and
release the key V immediately.
The appropriate service functions are displayed in relation
to the selected program (LED D + knob I).
In MMA:
AF Activated in MMA welding. You may adjust from 0
to 100%. Adjusts the dynamic characteristic of the arc, a
value adjusted using the knob L.
T
U