Description Of Functions Shown On The Display A - Cebora POWER SPOT 5700 Instruction Manual

5.3

Description of functions shown on the display A.

A few seconds later, the following screen will appear on the display A:
a
Stud bolt
b Base material
c Rivet material and dimensions
NOTE: the maximum rivet length that can be used is 30mm (1-1/4")
d Type of base material
e
Indication as to weld quality.
This symbol with the letter Q indicates that the stud material and the base material that have been selected are
weldable, poorly weldable or non-weldable (See table 1).
good weldability
f
Indications/warnings during the welding phase. During welding phases these symbols provide process-related
indications:
f
f steadily lit: indicates that the power source is ready to carry out a welding operation.
f
f steadily lit: indicates that the stud bolt is in contact with the base material and the generator is ready to carry
out the welding operation.
f flashing: indicates that, after the welding was completed, the gripping clamp X of the gun was not removed
f
from the stud bolt.
f
f flashing: indicates that, after the welding was completed, the start button and microswitch inside the gun
were pressed during charging of the capacitors.
g
Value suggested by the force of the spring inside the gun (if the force setting is changed, it is recommended
also to change the value indicated on the display so that in the future this change will remain memorized. The
change from the suggested value will be indicated by an arrow pointing upward if it is increased or downward
if it is decreased).
h
Charge voltage of the capacitors (if the voltage setting is changed from the suggested value, it will be indicated
by an arrow pointing upward if it is increased or downward if it is decreased).
During the adjustment, the voltage value will flash to indicate that the generator is working to reach the requested
value. Whilst the voltage value is flashing, it is not possible to perform any welding operation.
3301291 3300103/D
When the machine is switched on, for a few seconds the display A will show the machine item
number, version and development date of the software.
a
b
f
g
poor weldability
c
e
d
h
non-weldable
21