Inserting the Camera
1. Remove any lanyard or neck strap which may be attached to the
camera.
2. Remove the camera Mounting Plate from the inside bottom of the
housing.
3. Line the mounting screw up with the camera's tripod socket. Use
a coin or flat head screwdriver (preferred) to tighten the mounting
plate to the camera.
Mounting Screw
1/4-20 Tripod
Attachment Hole
4. Pull out on the housing control knobs to move them out of the way.
5. Insert the mounting plate into the slot on the inside bottom of the
housing. Push the camera all of the way forward until the back of
the mounting plate is flush with the back of the housing mount.
6. OPEN the camera flash AFTER the camera has been installed in
the housing front. Once the housing back is attached and closed,
the camera flash cannot be opened.
10
Camera Tripod
Socket
Mounting Plate