Troubleshooting - Bissell 1858 series User Manual

Troubleshooting

WARNING
To reduce the risk of electric shock, turn power switch off and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
Problem Possible causes
Clean water tank may be empty
Reduced
Clean water tank may not be
spray OR
seated completely
no spray
Pump may have lost prime in
hose cleaning mode
Tanks may not be seated properly
Dirty tank has picked up
maximum amount of dirty water
and has reached full line
Clean water tank is empty
Loss of
Rubber tab on dirty water tank is
suction
not sealed tight
power
Accessory hose door may not be
closed tightly in place
Nozzle may be clogged from pet
hair or debris
Remedies
Refill tank
Turn power OFF. Remove and
reseat tank
Hold end of hose below water level
in tank to prime
Pick up both tanks and reseat them
so they fit properly on the unit
Empty dirty tank
Check fluid levels in the clean water
tank. Refill the tank if it is empty
Check the rubber tab on the dirty
water tank and press firmly on all
edges to secure it tightly (see step
4 on page 13 for detail)
Check the accessory hose door
and make sure it is closed tightly by
pushing down to lock into place.
Use the nozzle clean out tool
and follow steps on page 13 for
"Cleaning Nozzle"
www.BISSELL.com
19