Table of Contents
Advertisement
Available languages
Available languages
5.3
Storage
If the machine is out of service for a lengthy period of
time, it should be thoroughly cleaned (see chapter
5.1). Spray bright metal panels with a rustproofing
agent.
Store the machine only in dry rooms, where it is pro-
tected against weathering.
6
Troubleshooting
The determination of the causes of existing defects and their elimination always require
increased attention and caution. Pull out the mains plug beforehand!
Some of the most frequent defects and their causes are listed in the following chart. In case of other defects,
contact your dealer or the MAFELL customer service.
Defect
Machine cannot be switched on
Machine stops while drilling is in pro-
gress
Drill bit jams
7
Optional accessories
Stop plate, cpl.
Special drill mount
Supplementary handle, cpl.
Ejector drift 1 DIN 317
8
Exploded drawing and spare parts list
The corresponding information in respect of spare parts can be found on our homepage: www.mafell.com
Cause
No mains voltage
Carbon brushes worn
Mains failure
Blunt bit
-16-
Elimination
Check power supply
Take the machine to a MAFELL cus-
tomer service shop
Check mains back-up fuse
Replace the drill bit or resharpen it
Ref. No. 039 156
Ref. No. 039 160
Ref. No. 039 203
Ref. No. 093 001
Advertisement
Table of Contents
