How To Fill With Water; Dry Ironing - Russell Hobbs RHI 102 Instruction And Warranty Book

HOW TO FILL WITH WATER:

Note: It is recommended to use purified or mineral water.

Disconnect the iron from the mains supply outlet.

Turn the Steam Control / Self-Cleaning Knob to the
position.

Fill water through the Water Inlet Hole.

Fill up to the Max level of the water tank.
BEFORE USING YOUR IRON FOR THE FIRST TIME:

Clean the water tank and the steam vents on the soleplate to remove dust which
may have accumulated during the manufacturing process.

Some vapour may be given off when the iron is first used. This is safe and will
stop after a short time.

Remove protective wrappings and labels from the soleplate and clean it with a
soft, damp cloth.

Fill the iron as described in the HOW TO FILL WITH WATER section.

Place the iron on its heel and connect the iron to a suitable mains supply outlet.

Turn the Temperature Dial to the '●●●' position – the pilot light will start to glow.

The pilot light goes off when the required temperature is reached.

Turn the Steam Control / Self-Cleaning Knob to the
to come out of the holes in the soleplate.

Begin first time ironing with an old towel or old cotton garment.

When the water tank is empty and there is no more steam being produced then
the preparation work is complete and the iron is ready for proper use.

DRY IRONING:


Connect the iron to a suitable mains supply outlet.

Turn the Temperature Dial in a clockwise direction to select '●', '●●' or '●●●'
according to the recommendation of the garment label.

Move the Temperature Dial in an anti-clockwise direction to 'Min' when ironing is
complete to switch the iron off.

Disconnect the iron from the mains supply outlet.
position. Steam will start
6