Panasonic UF-9000 Service Manual page 199

Ver. 1.0
(4) Disconnect the Speaker Harness.
(5) Release the Harness from the Harness Clamp.
(6) Remove 7 Screws.
(7) Remove the SC Cover.
(8) Install the Hardware Key into the CN324
connector on the SC PC Board.
Note:
The connector is keyed, to prevent damage to the
SC PC Board, install the Hardware Key as
illustrated. Do not force the Hardware Key into the
connector if facing the wrong way.
(9) Proceed with the installation of other options.
If finished, reinstall all Harnesses and Covers.
(10) Plug the AC Power Cord and turn the Power
Switch on the Left Side of the machine to the ON
position.
(11) Reconnect the Telephone Line Cable if it was
disconnected.
(12) Update the firmware of the unit to the PS/PCL
Option firmware. Refer to section 8.1 Service
Notes of this manual.
(13) Install the PS/PCL6 Software into the PC with
the Operating Instructions by following the
prompts of the Installation Wizard.
(14) Attach the Adobe PostScript 3 Label to the Front
Cover as illustrated.
199
UF-9000
DP180/190
JAN 2004