Panasonic UF-9000 Service Manual page 128

Code Mode
415 XMT
(Polling)
416 RCV
417 RCV
418 RCV
420 RCV
421 RCV
422 XMT
427 G3
RCV
434 XMT or RCV
436 G3 RX
456 RCV
457 RELAY XMT
CONF. XMT/
POLL
459 RCV
490 RCV
494 RCV
495 XMT
RCV
Ver. 1.0
Fax Information Codes
Phase Description of Problem
B Remote side attempted to receive
message from your machine in
polling communication.
D Receiver did not detect post
command, such as EOP, MPS,
EOM, etc.
C Receiver returned RTN in
response to post message.
C Receiver transmitted PIN in
response to PRI-Q from
transmitter. (Transmitting operator
requests voice contact)
B T1 timer (35 sec.) elapsed without
detecting 300 bps signal.
B Busy Tone is detected after
sending NSF Signal.
B Content of NSF (or DIS) or NSC
(or DTC) was invalid.
B DCN received to NSF/CSI/DIS
transmitted.
B CD (response from Modem) did
not turn OFF within 180 sec. after
receiver detected FLAG signal.
C DCN received after transmitting
FTT.
B Received relay transfer request or
confidential document to distribute
to an end receiving station or all
confidential mailboxes are used.
B Remote unit does not have
Relayed XMT or Confidential
Comm. capability.
C Failed training in Phase C.
C Sum of error lines exceeded the
limit (Function Parameter No. 70)
of 64 lines.
C Interval between two EOLs was
more than 10 sec. when receiver
received message data.
C During reception, CD turned OFF
or continued ON for long time.
During communication, lost loop -
current.
Inform the remote side that your
machine does not have the polling
transmission feature.
Transmitter is defective.
Line quality is poor. (RTC signal is
distorted due to line noise)
SC PCB or FXB PCB are defective.
Line quality is poor. (There are
excessive errors in received data)
SC PCB or FXB PCB are defective.
Line quality is poor. (There are
excessive errors in received data)
SC PCB or FXB PCB are defective.
Incorrect incoming call type (voice).
(Non-facsimile communication)
Transmitter is defective.
SC PCB or FXB PCB are defective.
Remote station disconnected the line.
Wrong number is dialed.
There is an incompatibility.
The interface is incompatible.
Remote unit is defective.
SC PCB or FXB PCB are defective.
Transmitter is defective or incompatible.
Line quality is poor.
Line quality is poor. (Training signal is
distorted due to line noise)
SC PCB or FXB PCB are defective.
Line quality is poor.
SC PCB or FXB PCB are defective.
Transmitter is defective.
Line quality is poor. (EOL is damaged
due to line noise)
SC PCB or FXB PCB are defective.
Line is disconnected.
Transmitter is defective.
SC PCB or FXB PCB are defective.
128
UF-9000
DP-180/190
Cause
JAN 2004