Lippe Lift T80 Assembly Manual page 4

Position the platform in accordance with the assembly drawing and guide the lower track pipe
4.)
into the lower roller set (Observe item 6 on page 9). Arrange the lower track pipe in accordance
with the displayed sketch. Dimension Y is takes precedence over dimension Z. Dimension Z
gives the dimension between the lower edge of the lower track pipe (which as a rule has a length
of 1900 mm) and the level of the lower stop (floor). Possibly this dimension cannot be measured
directly on site because steps exist there. Then an auxiliary dimension should be computed on
site (reduced dimension Z) by subtracting the respective step height from dimension Z. The
auxiliary dimension then gives the vertical clearance between the end of the lower track pipe
(lower edge) and the step which lies perpendicular below it.
If the dimensions agree with those of the installation drawing, the lower rail should be fastened
either to the wall(see page7) or on the supports(see page 5) (Make sure that the lower cap is
present on the pipe). Only when the lower rail is completely installed will the upper rail be
inserted and mounted. The maximum clearance between the individual fastening points is
described in appendix 1 on page 19.
In the case of wall mounting on concrete/steel or by means of threaded rods, the fastening plates
should be attached as displayed on the next page. Here, keep the maximum clearances of the
fastening plates between each other as displayed in appendix 1(Page19).
Installation manual Konstanz DC
X
4/25
585
Z
Y
Version 8.0 Last update: 2/15/10