Lippe Lift T80 Assembly Manual page 13

11.) The stopping points should be set up as displayed below and on the next page. For this purpose,
bring the platform into the desired position and mark the corresponding positions of the operator
end switch on the top roller set, and the unlocking lobe on the lower roller set. The presetting
occurs by attaching the corresponding angle bracket to the rails. The fine setting is achieved using
the adjustable curves on the angle brackets. Important: The setting of the emergency end switch
should occur as curtly as possible (Set dimension X (display on the next page) as small as
possible).
Installation manual Konstanz DC
E
I
C: DIN933-M12x25 8.8 (M=50Nm)
E: DIN127 A12
H :DIN936-M12 8.8
I:DIN6912-M12x40 8.8 (M=50Nm)
C
E
H
A
A
5
Clearance min. 5mm
13/25
_
+
Version 8.0 Last update: 2/15/10