Lippe Lift T80 Assembly Manual page 18

The disassembly of a stairwell inclined elevator Konstanz
1.) Drive the load carrying equipment into the lowest position.
2.) Disassemble the electrical components (external control device, loading devices).
3.) Remove front paneling (establish access to the main switch, brake and hand wheel)
4.) Set the main switch to OFF.
4.) Disassemble the track parts starting with the uppermost stopping point and continuing
downwards (including the last track piece before the load carrying equipment).
Caution: There are absolutely occurring hazard sources such as e.g. risk of falling (missing
railing) or risk of cutting (sharp edges) which must be removed or secured in a
suitable manner!
5 Remove the load carrying equipment from the rail in a suitable manner:
- The load carrying equipment is standing on the floor:
Loosen the last track piece. Lift up the venting lever of the brake and simultaneously rotate the
hand wheel in the direction AB. The last track piece can then be carefully pulled out of the roller
heads.
- The load carrying equipment is not standing on the floor:
Lift up the venting lever of the brake and at the same time turn the hand wheel in the OFF
direction and pull the load carrying equipment upwards from the last track piece.
6.) Disassemble the supports (possibly separate supports which are welded together).
Observe the safety notes for working with heat for the prevention of fire risk.
Notes about disposal
1.) Steel scrap: steel parts of the track , supports and steel parts of the load carrying equipment
2.) Special waste: plastic parts, motors, cables, conductor plate, batteries
Note: Our powder coating is free of lead and cadmium
Installation manual Konstanz DC 18/25 Version 8.0 Last update: 2/15/10