Lippe Lift T80 Assembly Manual page 16

15.) In case a track paneling is planned, or must be attached, this should be attached as displayed
below. In the case of the track paneling the upper edge of the plexi-glass paneling should lie
approx. 150 mm (direct dimension) above the upper edge of the rail. The corresponding holes for
the screw M6 must be drilled on site. In case the fastening bolts on the side of the rail protrude
too far, then they should be shortened accordingly. Beware of collision hazard with the platform!
15a) Attachment of the lower pipes (fall protection), if required or planned.
Installation manual Konstanz DC
3.
2.
16/25
1.
3.
2.
1.
4.
6.
5.
Version 8.0 Last update: 2/15/10