Jeep WRANGLER 2017 Owner's Manual page 306

304 STARTING AND OPERATING
This system is controlled by the SWAY BAR switch located
on the instrument panel (to the left of the steering column).
Sway Bar Switch
Push the SWAY BAR switch to activate the system. Push
the switch again to deactivate the system. The "Sway Bar
Indicator Light" (located in the instrument cluster) will
illuminate when the bar is disconnected. The "Sway Bar
Indicator Light" will flash during activation transition, or
when activation conditions are not met. The stabilizer/
sway bar should remain in on-road mode during normal
driving conditions.
WARNING!
Do not disconnect the stabilizer bar and drive on
hard-surfaced roads or at speeds above 18 mph
(29 km/h); you may lose control of the vehicle, which
could result in serious injury. The front stabilizer bar
enhances vehicle stability and is necessary for main-
taining control of the vehicle. The system monitors
vehicle speed and will attempt to reconnect the stabi-
lizer bar at speeds over 18 mph (29 km/h). This is
indicated by a flashing or solid "Sway Bar Indicator
Light." Once vehicle speed is reduced below 14 mph
(22 km/h), the system will once again attempt to return
to off-road mode.
To disconnect the stabilizer/sway bar, shift to either 4H or
4L and push the SWAY BAR switch to obtain the off-road
position. Refer to "Four-Wheel Drive Operation" in this
section for further information. The "Sway Bar Indicator
Light" will flash until the stabilizer/sway bar has been
fully disconnected.