Jeep WRANGLER 2017 Owner's Manual page 191

To Change The Compass Variance:
1. Turn the ignition switch RUN (it is not necessary to start
the engine).
2. Push the MENU button until Personal Settings
(Customer-Programmable Features) displays in the in-
strument cluster display.
3. Push the down arrow button until "Compass Variance"
message and the last variance zone number displays in
the instrument cluster display.
4. Push and release the right arrow button until the proper
variance zone is selected according to the map.
5. Push and release the COMPASS button to exit.
Digital Speedometer
Shows the actual vehicle speed in mph or km/h.
Average Fuel Economy
Shows the average fuel economy since the last reset.
Average fuel economy can be reset by pushing and holding
the right arrow button (as prompted in the instrument
cluster display). Upon reset, the history information will be
erased, and the averaging will continue from the last fuel
average reading before the reset.
GETTING TO KNOW YOUR INSTRUMENT PANEL 189
Distance To Empty (DTE)
Shows the estimated distance that can be traveled with the
fuel remaining in the tank. This estimated distance is
determined by a weighted average of the instantaneous
and average fuel economy, according to the current fuel
tank level. DTE cannot be reset.
NOTE: Significant changes in driving style or vehicle
loading will greatly affect the actual drivable distance of
the vehicle, regardless of the DTE display value.
When the DTE value is less than 30 miles (48 km) estimated
driving distance, the DTE display will change to a text
display of LOW FUEL." This display will continue until
the vehicle runs out of fuel. Adding a significant amount of
fuel to the vehicle will turn off the LOW FUEL text, and a
new DTE value will display.
Tire Pressure — If Equipped
Push and release the MENU button until "Tire PSI/kpa:"
displays in the instrument cluster display. It shows a
graphic of the vehicle with a tire pressure value at each
corner of the graphic.
4