Table of Contents
Advertisement
figure 5.29
5 - Using the ARC 2 Plug-In
5.3.4 Mode selector
This control lets you choose the mode in which ARC 2 will monitor your
audio (figure 5.29). When set to "Stereo," ARC 2 will reproduce the corrected
L/R program on your DAW's master bus. Setting it to "Mono" or "Side" will
allow you to monitor the program in Mono (channels sum) or in Side (chan-
nels difference).
5.3.5 MIDI Assign of Remote Controls
All controls can be assigned to an external hardware controller sending
MIDI commands for hands on-operation. To do this, just right click on the
parameter you want to be remotely controlled. A "MIDI learn" message
(figure 5.30) will show that ARC 2 is waiting for a MIDI input. Move the
hardware controller (dial, encoder, etc..) you want to assign to it, and it will
be instantly linked to the selected parameter.
figure 5.30
5.4 Opening the ARC 2 Plug-In in your DAW
The ARC 2 Plug-In is a "stereo-to-stereo" processor that should be inserted
on the stereo master bus of your audio sequencer or digital audio worksta-
tion.
The ARC 2 Plug-In should remain inserted and active on the stereo master
bus during the entire recording, mixing and mastering processes. But then
just before printing the final mix to a file or to an external recording
device, it should be turned OFF.
This is because the ARC 2 Plug-In is used to correct the monitoring/room sys-
tem response. It is NOT intended to process the actual mixdown of your project.
A few DAWs support a dedicated monitoring bus where you can insert plug-ins.
In this case, the ARC 2 Plug-In should be inserted on the monitoring bus instead
of the stereo master bus so that the ARC 2 Plug-In will not affect the actual
mixdown of your project even if you don't turn it OFF before printing the mix.
ARC System 2
51
Advertisement
Table of Contents
