Enable The Dhcp Client - NETGEAR WAC510 User Manual

5. Select the Disable radio button.
If the access point functions in Router mode and you selected the WAN menu option, the page also
displays the WAN Interface field, which is fixed at WAN (Ethernet Port).
6. Specify the settings that are described in the following table.
If the access point functions in AP mode, use the information that is shown in the AP Mode column.
If the access point functions in Router mode, use the information that is shown in the Router Mode
column.
Setting
IP Address
Subnet Mask
Gateway
Primary DNS
Secondary DNS
7. Click the Apply button.
Your settings are saved. The access point restarts with the new IP settings.

Enable the DHCP Client

By default, the DHCP client of the access point is enabled and the access point receives an IP address from
a DHCP server.
How your access point receives its IP address depends on whether it functions in AP mode (which is the
default system mode) or Router mode:
AC WiFi Business Access Point WAC510
AP Mode
IP address in the range that is used by your
LAN (usually 255.255.255.0).
The subnet mask must be compatible with
your LAN.
IP address of the gateway on your LAN.
IP address of the primary Domain Name
System (DNS) server on your LAN.
IP address of the secondary DNS server on
your LAN, or leave this field blank.
Manage the Local Area Network and IP Settings
Router Mode
IP address in the range that is used by your
Internet modem.
The subnet mask must be compatible with
your Internet modem.
IP address of the gateway that is used by
your Internet modem.
IP address of the primary DNS server that
is used by your Internet modem.
IP address of the secondary DNS server
that is used by your Internet modem, or
leave this field blank.
72