Use The Web Management Interface - NETGEAR WAC510 User Manual

WARNING:
To avoid the risk of corrupting the firmware, do not interrupt the reset. For
example, if you are connected to the access point's web management interface,
do not close the browser, click a link, or load a new page. Do not turn off the
access point. Wait until the access point finishes restarting and the Power
LED turns solid green.

Use the Web Management Interface

You can use the access point's web management interface to return the access point to its factory default
settings.
CAUTION:
This process erases all settings that you configured in the access point.
To erase the settings:
1. Open a web browser from a computer that is connected to the same network as the access point or to
the access point directly through an Ethernet cable or WiFi connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
3. Enter the access point user name and password.
The default user name is admin. The default password is password. The user name and password
are case-sensitive.
The Dashboard page displays.
4. Select Management > Maintenance > Reset > Restore Defaults.
The Restore Defaults page displays.
5. Click the Restore Defaults button.
The configuration is reset to factory default settings. When the reset is complete, the access point
reboots. This process takes about two minutes.
WARNING:
To avoid the risk of corrupting the firmware, do not interrupt the reset. For
example, do not close the browser, click a link, or load a new page. Do not
turn off the access point. Wait until the access point finishes restarting and
the Power LED turns solid green.
AC WiFi Business Access Point WAC510
Manage and Maintain the Access Point
95