Enable Or Disable Upnp; Manage Dhcp Servers - NETGEAR WAC510 User Manual

• Enable. LLDP is enabled. This is the default setting.
• Disable. LLDP is disabled.
6. Click the Apply button.
Your settings are saved.

Enable or Disable UPnP

Universal Plug-N-Play (UPnP) lets the access point be discovered by other devices in the network that
support UPnP. UPnP is enabled by default.
To enable or disable UPnP:
1. Open a web browser from a computer that is connected to the same network as the access point or to
the access point directly through an Ethernet cable or WiFi connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
3. Enter the access point user name and password.
The default user name is admin. The default password is password. The user name and password
are case-sensitive.
The Dashboard page displays.
4. Select Management > Configuration > System > Advanced > UPnP.
The UPnP page displays.
5. Select one of the following radio buttons:
• Enable. UPnP is enabled. This is the default setting.
• Disable. UPnP is disabled.
6. Click the Apply button.
Your settings are saved.

Manage DHCP Servers

When the system mode of the access point is Router mode (see
or AP Mode on page 84), you can add up to seven Dynamic Host Configuration Protocol (DHCP) servers
in addition to the default DHCP server. (The access point can support a total of eight DHCP servers.) These
DHCP servers can issue IP addresses from different address pools to the WiFi clients of the access point.
The access point delivers the following settings to any WiFi device that requests DHCP:
• An IP address from the range that you define
• Subnet mask
AC WiFi Business Access Point WAC510
Manage the Local Area Network and IP Settings
Change the System Mode to Router Mode
77