Tire Pressure Monitoring Low Pressure Warnings; Service Tpm System Warning - Jeep grand cherokee 2016 Operating Information Manual

Hide thumbs Also See for grand cherokee 2016:
Table of Contents

Advertisement

Tire Pressure Monitoring Low
Pressure Warnings
The Tire Pressure Monitoring Telltale
Light will illuminate in the instrument
cluster, and an audible chime will be
activated, when one or more of the
four active road tire pressures are low. In addi-
tion, the DID will display a "Tire Low" message,
an "Inflate to XXX" message and a graphic
display of the pressure value(s) with the low
tire(s) displayed in a different color. Refer to
"Driver Information Display (DID)" in "Under-
standing Your Instrument Panel" for further
information.
NOTE:
Your system can be set to display pressure
units in PSI, BAR or kPa.
280
Low Tire Pressure Monitor Display
Should a low tire condition occur on any of the
four active road tire(s), you should stop as soon
as possible, and inflate the low tire(s) that is in
a different color on the graphic display to the
vehicle's recommended cold tire pressure dis-
played in the "Inflate to XXX" message.
NOTE:
When filling warm tires, the tire pressure
may need to be increased up to an additional
4 psi (30 kPa) above the recommended cold
placard pressure in order to turn the Tire
Pressure Monitoring Telltale Light off.
The system will automatically update, the
graphic display of the pressure value(s) will
return to its original color and the Tire Pressure
Monitoring Telltale Light will extinguish once the
updated tire pressure(s) have been received.
The vehicle may need to be driven for up to 20
minutes above 15 mph (24 km/h) to receive this
information.

SERVICE TPM SYSTEM Warning

The Tire Pressure Monitoring Telltale Light will
flash on and off for 75 seconds, and remain on
solid when a system fault is detected. The
system fault will also sound a chime. The DID
will display a "SERVICE TPM SYSTEM" mes-
sage for a minimum of five seconds. This mes-
sage is then followed by a graphic display, with
"- -" in place of the pressure value(s), indicating
which Tire Pressure Monitoring Sensor(s) is not
being received.
If the ignition switch is cycled, this sequence will
repeat, providing the system fault still exists. If
the system fault no longer exists, the Tire Pres-
sure Monitoring Telltale Light will no longer
flash, the "SERVICE TPM SYSTEM" message

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents