Jeep grand cherokee 2016 Operating Information Manual page 247

Radar sensor removal
equipped with Adaptive Cruise Control
[ACC]):
1. With the lower fascia removed, which pro-
vides access to the sensor and bracket,
disconnect the wiring harness from the sen-
sor.
2. Using a suitable tool, disconnect the wire clip
from the bracket.
3. Using a suitable tool, remove the two fasten-
ers that hold the sensor bracket to the bum-
per beam.
NOTE:
It is recommended to scribe location to
assist in reinstallation.
4. Locate the protective connector on the rear
of the bumper beam.
procedure (If
1 — Inside Bumper Beam
2 — Protective Connector Location
3 — Sensor Bracket Fasteners
4 — Sensor Bracket
NOTE:
Only models with the Off Road Package are
equipped with the a protective connector.
5. Remove the plug from the protective con-
nector and install on the sensor.
6. Insert the wiring harness connector into the
protective connector.
7. Store sensor and bracket in a safe place.
NOTE:
All cruise control functions will be disabled
when the radar sensor is disconnected.
Radar sensor installation procedure (If
equipped with Adaptive Cruise Control
[ACC]):
1. Disconnect the wiring harness connector
from the protective connector on the bumper
beam.
2. Remove plug from radar sensor and install in
protective connector.
3. Using the previously scribed marks, reinstall
the radar sensor and bracket using the two
fasteners.
NOTE:
Some alignment may be required upon fas-
cia installation to align sensor with fascia.
4. Install the wiring harness connector into the
radar sensor.
243