5 SETTINGS
d) SESSION SETTINGS
PATH: SETTINGS
PRODUCT SETUP
SESSION
SETTINGS
MESSAGE
The following session settings are available.
•
SESSION LOCKOUT: This setting specifies the number of failed authentications (the default is three and the maxi-
mum is 99) before the device blocks subsequent authentication attempts for the lockout period. A value of zero means
lockout is disabled.
•
SESSION LOCKOUT PERIOD: This setting specifies the period of time in minutes of a lockout period (the default is
three and the maximum is 9999). A value of 0 means that there is no lockout period.
e) RESTORE DEFAULTS
PATH: SETTINGS
PRODUCT SETUP
RESTORE DEFAULTS
•
LOAD FACTORY DEFAULTS: This setting is used to reset all the settings, communication and security passwords. An
Administrator role is used to change this setting and a Supervisor role (if not disabled) approves it.
f) SUPERVISORY
PATH: SETTINGS
PRODUCT SETUP
SUPERVISORY
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
GE Multilin
SECURITY
SESSION SETTINGS
SESSION LOCKOUT:
3
SESSION LOCKOUT
PERIOD: 3 min
SECURITY
RESTORE DEFAULTS
LOAD FACTORY
DEFAULTS: No
SECURITY
SUPERVISORY
LOCAL
AUTHENTICATION:Yes
BYPASS ACCESS:
Disabled
LOCK RELAY:
Disabled
FACTORY SERVICE:
MODE: Disabled
SELF TESTS
SUPERVISOR ROLE:
Disabled
SERIAL INACTIVITY
TIMEOUT: 1 min
C30 Controller System
5.2 PRODUCT SETUP
Range: 0 to 99
Range: 0 to 9999 minutes
Range: Yes, No
Range: Yes, No
Range: Enabled, Disabled
Range: Enabled, Disabled
Range: Enabled, Disabled
See below
Range: Enabled, Disabled
Range: 1 to 9999 minutes
5
5-13