Metering; Flexelements; Iec 61580 Goose Analog Values; Transducer Inputs/Outputs - GE C30 Instruction Manual

6 ACTUAL VALUES

6.3METERING


PATH: ACTUAL VALUES METERING
 FLEXELEMENT 1

The operating signals for the FlexElements are displayed in pu values using the following definitions of the base units.
Table 6–1: FLEXELEMENT BASE UNITS
dcmA
FREQUENCY
PHASE ANGLE
POWER FACTOR
RTDs
SOURCE CURRENT
SOURCE POWER
SOURCE VOLTAGE

PATH: ACTUAL VALUES METERING
 IEC 61850
 GOOSE ANALOGS
MESSAGE
MESSAGE
MESSAGE
The C30 Controller System is provided with optional IEC 61850 communications capability. This feature is
specified as a software option at the time of ordering. Refer to the Ordering section of chapter 2 for addi-
tional details.
The IEC 61850 GGIO3 analog input data points are displayed in this menu. The GGIO3 analog data values are received
via IEC 61850 GOOSE messages sent from other devices.

PATH: ACTUAL VALUES METERING
 DCMA INPUT xx

Actual values for each dcmA input channel that is enabled are displayed with the top line as the programmed channel ID
and the bottom line as the value followed by the programmed units.
GE Multilin
 

FLEXELEMENTS

FLEXELEMENT 1(8)
FLEXELEMENT 1
OpSig: 0.000 pu
BASE = maximum value of the
DCMA INPUT MAX
under the +IN and –IN inputs.
f = 1 Hz
BASE

= 360 degrees (see the UR angle referencing convention)
BASE
PF = 1.00
BASE
BASE = 100°C
I = maximum nominal primary RMS value of the +IN and –IN inputs
BASE
P = maximum value of V
BASE BASE
V = maximum nominal primary RMS value of the +IN and –IN inputs
BASE

IEC 61850 GOOSE ANALOGS
ANALOG INPUT 1
0.000
ANALOG INPUT 2
0.000
ANALOG INPUT 3
0.000

ANALOG INPUT 32
0.000

TRANSDUCER I/O DCMA INPUTS
DCMA INPUT xx
0.000 mA
C30 Controller System
setting for the two transducers configured
 I
for the +IN and –IN inputs
BASE

6.3.2 IEC 61580 GOOSE ANALOG VALUES

6.3.3 TRANSDUCER INPUTS/OUTPUTS


DCMA INPUT xx
6.3 METERING
6.3.1 FLEXELEMENTS
6
6-11