Making Wi-Fi Settings By Push Button Setup - Epson ET-3600/L605 User Manual

User's Guide
4. Enter the password, and then press the OK button.
Note:
❏ The password is case-sensitive.
❏ If you do not know the password, check if it is written on the label of the access point. If you are using the access point
with its default settings, use the password written on the label. The password may also be called a "Key", a
"Passphrase", and so on.
❏ If you do not know the password for the access point, see the documentation provided with the access point, or
contact the person who set it up.
5. Confirm the settings by pressing the
6. Press the OK button to finish.
Note:
If you fail to connect, load paper, and then press the
Related Information
"Entering Characters" on page 16
&
"Checking the Network Connection Status" on page 25
&
"When You Cannot Make Network Settings" on page 113
&

Making Wi-Fi Settings by Push Button Setup

You can automatically set up a Wi-Fi network by pressing a button on the access point. If the following conditions
are met, you can set up by using this method.
❏ The access point is compatible with WPS (Wi-Fi Protected Setup).
❏ The current Wi-Fi connection was established by pressing a button on the access point.
Note:
If you cannot find the button or you are setting up using the software, see the documentation provided with the access point.
1. Select Wi-Fi Setup on the home screen, and then press the OK button.
2. Select Push Button Setup (WPS), and then press the OK button.
3. Hold down the [WPS] button on the access point until the security light flashes.
Network Settings
d
button, and then press the OK button.
x
button to print a network connection report.
21