Do I Need To Load Any Software To Get Started; Is There Anything I Should Not Do With The Device While I Am Learning To Use It; Is There Anything I Need To Assemble Before I Turn It On; How Do I Begin To Use The Digital Tablet And In-Wall Touch Screen Immediately - Pentair Intellitouch ScreenLogic User Manual

90

Do I need to load any software to get started?

The Digital Tablet, PDA, and in-wall Touch Screen comes pre-installed with all the software you will need to surf
the Internet, set up e-mail, run local applications, and interact with servers and PCs. These devices provide a means
to install new software that may enhance the function and value of the device. Note: Such applications are not
supported by Pentair Water.

Is there anything I should NOT do with the device while I am learning to use it?

The touch screen is made of glass, and is therefore fragile. Treat it as you would a piece of glass. Please use the
stylus provided with the Digital Tablet or another stylus designed for use with touch-panels. Do not use a sharp
objects such as pens or other pointing devices to touch the screen, you may scratch the screen.
Do not spill liquid onto the device, especially if the device is powered on. In general, do not operate without
reading all cautions and directions in this manual.

Is there anything I need to assemble before I turn it on?

The Digital Tablet and PDA comes fully assembled. You will only need to charge the battery by connecting the A/C
adapter to the unit, and plugging it into a wall socket. For an enhanced handling experience, the system may come
with accessories such as a protective rubber grip handles which you will have to slip over the Digital Tablet and a
shoulder strap.

How do I begin to use the Digital Tablet and in-Wall Touch Screen immediately?

Powering On:
Depending on how you received the device, your Digital Tablet or in-wall Touch Screen device may be in a
Suspend state or in a Power Off state. Connect the AC adapter provided with the device directly to the power
input jack of the Digital Tablet or to power input jack on the cradle for the device with the Digital Tablet securely
seated. Use only the AC adapter provided with the device or purchased as a specific accessory, your device may
not operate and may be damaged if you use the incorrect AC adapter.
With the AC-DC adapter connected:
• Press firmly but briefly on the Suspend button on the left edge of the device.
• Wait a few seconds, if the display does not light up, make sure that all power connections are in place and try
again.
• If the display still does not light up then try the following before contacting Technical Support (see page viii).
• If you have been using the Cradle, try connecting the power directly to the device instead, and repeat the
option above, OR,
• With the AC adapter still connected, push on the Suspend button located along the left edge and hold on for
over 4 seconds. Release the Suspend button. Then push on the Suspend button again briefly.
If all the steps above fail to turn on the device then you should contact Technical Support (see page viii).
After the device turns on, you should charge the device battery with the AC adapter. You may continue to use the
device while the charging process is proceeding.
IntelliTouch ScreenLogic User's Guide