Low Battery Condition (Tablet And Pda); Power On And Off (Tablet And Pda); Battery And Power Management (Tablet); Battery And Power Management (Pda) - Pentair Intellitouch ScreenLogic User Manual

Pentairwater pool and spa intellitouch screenlogic user's guide
Hide thumbs Also See for Intellitouch ScreenLogic:
Table of Contents

Advertisement

14

Low Battery Condition (Tablet and PDA)

A warning message will be generated during a low battery condition and the Tablet and PDA will shortly thereafter
be placed into (Forced) Suspend mode if operation continues without external supply of power.
When a low battery condition occurs, the PDA will notify you that its battery is low, then it will automatically turn
off the wireless radio to conserve battery life. Please recharge the PDA and re-enable its wireless radio by pressing
the wireless On/Off button (see page 8).
After the Digital Tablet enters the (Forced) Suspend mode due to the Low Battery condition:
If over two to four hours elapse without using the AC adapter or the external battery pack to resume
system operation or recharge the battery, the battery power will drain entirely. If the Tablet is
reactivated then, the device is reset and the process amounts to a cold boot. You can also reactivate the
system by briefly pressing the Suspend button with a connected AC adapter or charged external battery.

Power ON and OFF (Tablet and PDA)

The battery shipped with your device should be low in power – please be prepared to use the AC adapter
with the Tablet and PDA in setting up the device for the first time and to fully charge the internal battery pack.
Depending on the origin of your device, the Tablet and PDA is generally delivered in a "Power Off" state. To
start (Cold Boot or "Power On") the Tablet and PDA for the first time, push briefly on the Suspend or
Power/Reset button located at the upper left edge of the device with the AC adapter connected to the
device.

Battery and Power Management (Tablet)

The Tablet is equipped with an internal Li-Ion battery pack that is capable of supporting approximately 2.5 hours
of continuous operation. The period between battery recharge can be significantly lengthened by putting the device
into Suspend mode through the Suspend button whenever the device is not in use.
Note: The Tablet battery pack may be recharged with the provided AC adapter connected directly to the
DC-in jack on the Tablet or connected to the Tablet cradle.

Battery and Power Management (PDA)

The PDA is equipped with an internal Li-Ion battery pack that is capable of supporting approximately 3.5 hours of
continuous operation.
IntelliTouch ScreenLogic User's Guide

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents