Screenlogic Wireless Connection Kit - Pentair Intellitouch ScreenLogic User Manual

ScreenLogic Wireless Connection Kit

The ScreenLogic Wireless Connection kit (P/N 520639) consists of two wireless 900 Mhz transceivers which
provides a wireless connection between the ScreenLogic Protocol adapter and the IntelliTouch Load Center
located at the equipment pad. This wireless connection eliminates the existing hard wire connection from inside
your home to the equipment pad.
The diagram below shows the wireless transceiver locations. The transceiver connected to the IntelliTouch Load
Center is connected to the Personality board COM port. The other transceiver is connected to the Protocol
Adapter located inside the home.
Load Center to Protocol Adapter wireless connection diagram
RJ11 for DSL
Coax for Cable
INTERNET
DSL or
Cable Modem
Ethernet cable
(RJ45 - CAT 5)
Cable distance limits:
- Ethernet cable distance limit = 300 feet
- Four-wire cable distance limit = 1500 feet
Note: (*) Optional wiring for existing Indoor
Control Panel. Tap into the Indoor Control Panel
connector or pig tail off the four-wire cable
connected to the Personality board.
Existing wired or wireless
router (mandatory)
ScreenLogic
Wireless router
1 2 3 4
WAN
RJ11 RJ45
(RJ45)
- LAN -
1 2 3 4 WAN
Ethernet cable (RJ45 - CAT 5)
Existing PC
Wireless Digital Tablet
Transceiver
connected to
ScreenLogic
Protocol adapter
In-wall touch
screen
4-wire 1 foot cable
AC power
adapter
Protocol
Adapter
Indoor Control
Panel (*)
Wireless PDA
Wireless transceiver
connected to Personality
board (COM port)
via 10' cable
Load Center
(Located outside at
equipment pad)
IntelliTouch ScreenLogic User's Guide
97