Emergency Disarming Without The Keychain Remote - LaserShield Instant Security Systems Owner's Manual

ABOUT ALARMS AND EMERGENCIES
When an Alarm Signal is Received
RRMS will:
1. Electronically phone the premises of the
alarm to attempt to verify a real
emergency and thus avoid a false alarm
dispatch. This call is usually received
within 30 seconds of the siren activation.
2.
If someone at the premises does not use
the 5 digit Passcode from your
emergency card to cancel the alarm, a
live operator will attempt to notify to
notify the appropriate authorities or
Responsible Parties.
3.
As the live operator contacts the
authorities, RRMS will phone you and/or
a Responsible Party that you have
designated on your Rapid Response
Information Form.
Important- If after 60 seconds you have
not been contacted by RRMS and the
alarm activation was accidental, contact
Customer Care immediately. You may not
have heard the phone over the alarm siren
and law enforcement may have been
notified.
24/7 monitoring is an important precaution
as a method to notify and deter you from
walking in on an intruder or dangerous
situation. In some cases, law enforcement
may remain at the location until the location
can be secured, or until a responsible party
arrives to relieve them. Notification is also
an important precaution to avoid leaving a
premise with a broken door or window
vulnerable to vandalism, weather, and other
unwanted intruders.
Note- You may update your emergency
contact information at anytime using the
Internet or by contacting Customer Care.
Remember, you may require a police permit
to qualify for law enforcement response. In
some areas law enforcement will not
respond to private alarms.
Check with local authorities regarding law
enforcement response to Alarm Systems.
Do not call 911 for this
information.
Avoid any potential false alarm
fines: Only press the Panic Button
if there is an actual emergency
situation.
Some communities may charge a
fee for each time law enforcement
officers are dispatched for a false
alarm.
Emergency Disarming WITHOUT the
Keychain Remote, Using a Tap Count
on the Master Alarm Unit
If your siren is sounding and you cannot
disarm your System, you can use the Tap
Count feature to silence the siren. Locate
your Tap Count number printed on your
LaserShield ® Emergency Card. Go to the
Master Alarm Unit and tap the On/Off
button the same number of times equal to
your Tap Count Number, and then press the
MAU Panic Button to silence the siren.
For example - if your Tap Count number is
7, then press the ON/OFF button 7 times,
and then press the Panic button on the
MAU.
If you forget how many times you have
pushed the ON/OFF button, pause for one
second and the Master Alarm Unit will
verbally announce the number of taps you
have entered. If you pause for 5 seconds or
more between taps during the count, you
must start over.
®
LaserShield Instant Security System OWNER'S MANUAL Page 17