'Unlinking' Or Deactivating Devices - LaserShield Instant Security Systems Owner's Manual

'UNLINKING' OR DEACTIVATING DEVICES

Deactivating or "Unlinking" a Single
Remote Device
If you want to stop using a Keychain
Remote or a WDU, you must unlink it. This
will remove the device from the MAU's
memory and prevents unauthorized use or
accidental alarms.
To Deactivate a Single Device:
1.
Press the "Learn" button on the back of
the MAU to enter "Learn" mode.
2.
Press the "Panic" button on the specific
remote device you want to deactivate.
On a Keychain Remote, press both
buttons at the same time. The MAU will
announce that the device is already
stored in memory and then will ask
you to press the Panic button again
to erase it.
3.
Press the Panic button again. The MAU
will announce that the device has been
erased.
4.
Repeat this process to deactivate other
remote devices you may wish to remove.
5.
Exit Learn Mode by pressing the Learn
button on the rear of the MAU.
Deactivating or Unlinking ALL Your
Remote Devices
A lost Keychain Remote could allow an
intruder who finds it to enter your home or
business without triggering the alarm. If a
Keychain Remote is lost, you will need to
deactivate all your remote devices, and
then re-link the devices you still have.
How to Unlink All Your Remote
Devices
1.
Press the "Learn" button on the back of
the MAU. The MAU will enter the "Learn"
mode.
2.
Press the Panic button on the MAU. The
MAU will prompt you to push the panic
button again to erase all devices.
3.
Press the Panic button again within 10
seconds. This erases all devices from the
MAU's memory.
4. Proceed directly to the next section for
Re-linking.
Re-linking the Remaining Remote
Devices
1.
Press the Panic button combination (arm
and disarm simultaneously) on each
Keychain Remote. This will reactivate
each Keychain Remote.
2.
Press the Panic Button on each WDU in
your System to reactivate them.
3. Listen to the announcement from the
MAU for each device before moving on to
the next one.
®
For other LaserShield
System, press the Panic Button on each to
reactivate it. When you have re-linked all
remaining devices press the learn button to
exit learn mode.
Note: If you wait longer than 60 seconds
between re-linking devices, the MAU will
automatically exit the Learn mode. You can
always press the Learn button to pick up
where you left off. Press the learn button to
exit learn mode.
®
LaserShield Instant Security System OWNER'S MANUAL
devices in your
Page 13