Arming And Disarming The System Arming The System When You Leave The Premises Using A Keychain Remote; Disarming The System When You Enter The Premises; Arming The System At Night; Checking The System Status - LaserShield Instant Security Systems Owner's Manual

ARMING AND DISARMING YOUR SYSTEM
Use your Keychain Remote to:
•
Arm and disarm the System.
•
Activate a Panic Alarm.
• Announce System status.
Arming with Your Keychain Remote
When the System is "armed" LaserShield
protects your residence or business by
triggering an alarm when it senses motion.
Arm the System when you leave the premises
or go to bed. An exit delay allows you time to
leave.
Press and release the "Arm" button on your
Keychain Remote. The MAU will verbally
announce, "LaserShield Arming."
You then have 60 seconds to leave the
premises after arming the System (the exit
delay period). The green status light on the
front panel of the MAU will blink rapidly during
the exit-delay period, and the MAU will
announce the time remaining in the exit-delay
period.
At the end of the delay period, the MAU will
announce, "LaserShield is armed," and the
amber status light will blink.
Do not move in front of the motion sensor
while it is armed, or you will trigger the
alarm.
Disarming the System When You Enter
the Premises
You have 20 seconds to disarm your System
after entering the protected area. This is the
"entry delay" period. The MAU starts beeping
loudly as a reminder to disarm your System.
•
Press the Disarm button on the Keychain
Remote. The MAU will announce,
"LaserShield disarmed."
Arming at Night
You can arm the System from your bedside at
night. If you have a Wireless Detection Unit in
your bedroom you should bypass it while you
sleep. You can do this by pressing its Bypass
button before arming. You may then move
about your bedroom at night, but you must
avoid walking into areas protected by other
WDUs.
If you have bypassed a WDU, you must press
®
the Arm button twice to arm it in bypass
mode. The MAU will announce the bypassed
status and will prompt you to fix the condition
or "press the Arm button again to force
arming". The WDU amber bypass light and
the MAU amber status light will flash during
bypass mode. Panic button will still be
functional on WDUs in bypass mode.
Disarm the System when you wake in the
morning, or when you wish to walk about your
premises. The MAU will always remind you
about a bypass condition at the time of
arming to prevent you from exiting the
following day without removing the bypass
condition. To remove the bypass status simply
press the bypass button.
Force Arming
If an abnormal condition exists with your
System, such as a low battery, loss of AC
power, etc., the MAU will announce the
condition during arming or disarming. It will
always ask you to fix the condition or press
the Arm button a second time to force arming,
overriding the condition.
Checking the MAU System Status
If the amber status light on the MAU is
blinking, it means there is an abnormal
system condition. You can use your Keychain
Remote to check the System status. Merely
press either the Arm or Disarm button to hear
a verbal status report.
®
LaserShield Instant Security System OWNER'S MANUAL Page 15