Testing Your Setup - LaserShield Instant Security Systems Owner's Manual

TESTING YOUR SETUP

Testing your LaserShield
RESPONSE MONITORING SERVICE
Until you have completed this test process, your
alarm monitoring will not be in effect. Follow
these simple steps to complete a successful
test:
If you receive an immediate confirmation for
1.
service using the Internet, you may test your
service immediately. If you use fax or mail to
activate your monitoring service, wait until a
LaserShield
calls you to begin your test.
2.
Press a panic button on your Keychain
Remote, MAU or WDU. Allow the siren to ring
for 10 seconds before disarming.
3.
RRMS will call you to confirm the successful
communication between your System and
Rapid Response. You will be asked to provide
your 5 digit Passcode (located on your
emergency card) and to verify that you are
ready to begin fully active monitored alarm
service. Please contact LaserShield
Customer Care if your test was not
successful.
®
Page 12 LaserShield
® and RAPID
®
Customer Care representative
Instant Security System OWNER'S MANUAL
®