Pet Shield - LaserShield Instant Security Systems Owner's Manual

USING LASERSHIELD WITH PETS

Pet Shield

Pets can trigger false alarms by moving in
front of the motion sensor while the System
is armed.
LaserShield
narrows the coverage area of the motion
sensor window, both vertically and
horizontally, thus creating pet "safe zones"
where animals can pass.
Using the Pet Shield reduces the coverage
pattern of your motion sensor. We
recommend pets be isolated to a
non-protected area. If your pet must be
allowed to freely roam your premises then
using the Pet Shield allows you to set up a
basic coverage pattern for the motion
sensor.
Because cats and dogs jump on furniture,
place your WDU at a height where pets can
move safely beneath the detection area.
You can aim the coverage of your WDU by
watching the test light inside the motion
sensor window, while moving about or
allowing pets to move through the protected
area. You may have to rotate your WDU left
or right a bit to move detection coverage
away from the backs of furniture or areas
pets may access or frequent. Adjust the
position and height of the Wireless
Detection Unit so that your pets can move
about freely without triggering an alarm.
®
Page 18 LaserShield
® provides a Pet Shield that
Instant Security System OWNER'S MANUAL
To Install your Pet Shield
Slide the Pet Shield into the groove at the
bottom of the motion sensor window on the
Wireless Detection Unit. The Pet Shield
should slide snugly into place and against
the motion sensor window.
Motion Sensor Window
Pet Shield attaches here
over Motion Sensor Window
Pet Shield Off
Pet Shield On