Monthly Testing - LaserShield Instant Security Systems Owner's Manual

We recommend you test your System
monthly to assure it is working properly.
You must place your System in test mode
before testing so that RRMS does not
notify authorities. You can place your
account in test mode one of two ways:
1.
Go the LaserShield ®
www.lasershield.net and click on "My
Account". You will be asked to enter your
web user ID and web passcode you
chose when you activated your
monitoring service. Follow the
instructions to manage your account and
place your System in one hour test
mode. Then follow the procedure listed
immediately below titled "To test your
System".
2.
You may contact LaserShield
Care to place your System in one hour
test mode. You will need your 5 digit
passcode to place your System in test
mode. The LaserShield
number is located on your emergency
card with your passcode.
To Test Your System
1.
Press the Arm Button on the Keychain
Remote to arm the System.
2.
Allow the exit delay to expire and walk
through the protected area. Allow the
entry delay beeps to beep until the siren
sounds. Let the siren sound for a full 10
seconds.
3.
Disarm the alarm using your Keychain
Remote.
4.
To test panic button simply press the
panic button on any device you wish to
test, allow the sound to ring for 10
seconds, and disarm the System.
You should repeat this test for each WDU.

MONTHLY TESTING

website at
®
Customer
®
Customer Care
Each time you trigger an alarm you will
receive an immediate call back from RRMS
and you will be asked to enter your 5 digit
passcode. The most critical test is to
confirm successful communication to
RRMS. We recommend you repeat the test
process for each device.
After completing a full test of the System,
go back to the Internet, or contact
®
LaserShield Customer Care to place your
System back on active monitoring. If you do
not remove your account from test mode
your account will automatically return to
active, monitored status after 1 hour.
Your LaserShield ® will conduct its own
internal tests on power and battery
functions on a regular basis and will notify
you of any abnormal conditions during
arming or disarming.
Care and Maintenance
To clean, unplug the unit and wipe with a
slightly damp soft cloth. Be careful not to
scratch the delicate motion sensor
windows. Do not place the MAU or WDUs
in water or allow water to get inside them.
Do not use commercial cleaning
solutions.
®
LaserShield Instant Security System OWNER'S MANUAL Page 21