Emergency Card ..........7 Section TWO - Setting up Your LaserShield ®...
Page 3
Section FOUR - Additional Features Household Pets - the LaserShield Pet Shield ......18 ®...
Page 4
LaserShield Starter Kit to ® operate it when you are wet or standing in achieve adequate protection. You water. may expand your LaserShield ® Instant Security System to other rooms with additional Wireless Detection Units. Locate your LaserShield ®...
INTRODUCTION Thank you for choosing the LaserShield ® “Armed” and “Disarmed” Instant Security System. It is easy to set up When the System is “Armed,” and easy to operate. With just a few simple ® LaserShield Instant Security steps, your System will be ready to protect System is actively monitoring the your home or business from intruders.
• To find out if you need an alarm permit, please contact your local law enforcement agency for details. • Please DO NOT DIAL 911 for alarm permit information. ® Page 6 LaserShield Instant Security System OWNER’S MANUAL...
Red Power Light On / Off Bypass Button Power Plug Emergency Card Remote Passcode & Tap Count Keychain Remote Customer Care Telephone Number DISARM LASERSHIELD INSTANT SECURITY SYSTEM INCLUDES: • • LaserShield ® Master Alarm Unit Owner’s Manual • •...
System should be connected to a line not used for DSL. IMMEDIATELY AFTER INSTALLING DSL OR BROADBAND Connect devices in the following TELEPHONE SERVICE, YOU MUST TEST sequence, with the LaserShield ® THE SYSTEM’S SIGNAL TRANSMISSION closest to the wall outlet:•...
Obstructions such as furniture, Push and hold the Power Button on the MAU columns or narrow corridors can impair the until the voice says "LaserShield on." range of detection. Place an additional WDU in a master bedroom, as burglars tend to Where to Position the frequent this room.
You must teach your MAU to respond to the Keychain remote and detection units. You can do this easily and quickly by using the "Learn" mode. Using Learn Mode to Connect Devices Each LaserShield ® device has a unique identification code that the MAU learns. This code allows the MAU to respond to and report on the status of each device.
Just go to: w w w . l a s e r s h i e l d . n e t Click on "Activate LaserShield". Be prepared to enter the device ID number located on the bottom of your MAU. Next complete the online Rapid Response Service Monitoring Agreement and Information Form.
Rapid Response. You will be asked to provide your 5 digit Passcode (located on your emergency card) and to verify that you are ready to begin fully active monitored alarm service. Please contact LaserShield ® Customer Care if your test was not successful.
MAU for each device before moving on to the next one. Deactivating or Unlinking ALL Your Remote Devices ® For other LaserShield devices in your System, press the Panic Button on each to reactivate it. When you have re-linked all A lost Keychain Remote could allow an...
To verify your identity when canceling a response to an accidental alarm. • For monthly testing you will provide your Passcode to verify your identity. • When you access your System by remote telephone. ® Page 14 LaserShield Instant Security System OWNER’S MANUAL...
Arming with Your Keychain Remote WDUs. If you have bypassed a WDU, you must press When the System is "armed" LaserShield ® the Arm button twice to arm it in bypass protects your residence or business by mode.
Disarm the alarm using your Keychain Remote. • Prepare to give your Passcode when What Happens When the RRMS phones to verify the alarm. LaserShield Alarm Sounds: ® A 105-decibel siren sounds and will automatically turn off and reset after 5 Intrusion or Real Emergency minutes.
Count feature to silence the siren. Locate and law enforcement may have been your Tap Count number printed on your notified. LaserShield ® Emergency Card. Go to the Master Alarm Unit and tap the On/Off 24/7 monitoring is an important precaution...
USING LASERSHIELD WITH PETS Pet Shield To Install your Pet Shield Pets can trigger false alarms by moving in Slide the Pet Shield into the groove at the front of the motion sensor while the System bottom of the motion sensor window on the is armed.
Press 1 you are away from your property. You will to Arm the System need to use the 5 digit Passcode printed on your LaserShield ® Emergency Card for this to Disarm the System Press 2 process.
MAU for up to 12 hours. The Status light will blink if there is a power outage or low battery power. When power is restored after an outage, the battery will recharge automatically. ® Page 20 LaserShield Instant Security System OWNER’S MANUAL...
Go the LaserShield ® website at After completing a full test of the System, www.lasershield.net and click on "My go back to the Internet, or contact Account". You will be asked to enter your ® LaserShield...
Replacing Batteries Replacing the WDU Batteries Replacement batteries for the MAU can be Battery type: CR123A Lithium Batteries ® purchased from the LaserShield web site. (available at most electronic and camera Please recycle old batteries. They may be stores) recycled at retail electronics stores or at a local battery recycling location.
Wireless Detection Press Bypass Button to restore to system Unit is Bypassed Wireless Detection Press ON/OFF Button; Check power connections No AC Power Keychain Remote Replace with new battery Low Battery ® LaserShield Instant Security System OWNER’S MANUAL Page 23...
You may also log in through the internet at www.lasershield.net and manage your account by editing your address and new phone numbers when you are ready to operate your System at your new location. You may also fax and notify Customer Care to update your information.
Page 25
System work with my answering machine? ® Yes. LaserShield ® is designed for use with most answering machines. The LaserShield ® MAU has a built in telephone splitter that allows you to operate with a telephone and an answering machine from the same connection point.
LIMITED WARRANTY & LIABILITY LaserShield’s Warranty and Limitation of Liability are set forth on the Limited Warranty provided in this package with your System. ® Page 26 LaserShield Instant Security System OWNER’S MANUAL...
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced radio/TV technician for help. Any modifications to the unit, unless expressly approved by LaserShield Systems, Inc., could void the user's authority to ®...
Need help?
Do you have a question about the Instant Security Systems and is the answer not in the manual?
Questions and answers