Introduction; How Lasershield; Works - LaserShield Instant Security Systems Owner's Manual

Thank you for choosing the LaserShield
Instant Security System. It is easy to set up
and easy to operate. With just a few simple
steps, your System will be ready to protect
your home or business from intruders.
This LaserShield Owner's Manual
®
Shows You How to:
•
Properly position the LaserShield
Alarm Unit (MAU) and Wireless Detection
Units (WDUs) in your home or business.
•
Set up the MAU and activate the 24/7
Monitoring Service that monitors your
alarm for round-the-clock protection.
•
Operate your LaserShield
Security System, using the Keychain
Remote or by phone.
•
Test your System with Rapid Response
Monitoring Service (RRMS) the 24/7
monitoring service.
How Does LaserShield
The LaserShield ® Instant Security System is
complete and ready to use, with batteries
already installed. The Master Alarm Unit can
be set up anywhere near a telephone jack.
The Wireless Detection Unit (WDU) should
be located near a corner or wall with a clear
view of the front door or main entry and
positioned approximately 4 to 6 feet from the
floor. A motion sensor on the front panel of
the WDU scans an area of up to
approximately 1100 sq. ft., but does not
penetrate walls or windows.
When you activate the System and connect
to RRMS, the monitoring service responds to
alarm signals from your System. If an alarm
signal is received from your premises, RRMS
will attempt to notify you and/or any
responsible parties to initiate a response.
Each Wireless Detection Unit includes an
optional Pet Shield to block portions of the
motion sensor so your pet is less likely to
trigger an alarm.
®
® Master
When the System is Armed and
Motion is Detected:
•
®
Instant
•
Work?
®
•
Not for use outdoors.

INTRODUCTION

"Armed" and "Disarmed"
When the System is "Armed,"
®
LaserShield Instant Security
System is actively monitoring the
protection area and ready to take
action if an intruder enters.
When the System is "Disarmed"
you can move about the house
freely without triggering an alarm.
The System watches for motion from a
potential intruder within its coverage
area. If motion is detected by the WDU
the MAU will quickly countdown to an
alarm condition, unless disarmed.
Once an Alarm condition is detected, the
MAU sends a message to RRMS using
your telephone line. RRMS will attempt
to notify responsible parties and local
authorities in accordance with your
Monitoring Service Agreement.
The Master Alarm Unit, Keychain
Remotes, and Wireless Detection Units
include a "Panic Button" feature that lets
you signal an emergency at any time.
The Panic Alarm sounds the siren and
triggers a phone call to RRMS.
®
LaserShield Instant Security System OWNER'S MANUAL Page 5