Linking Your Units Wirelessly - LaserShield Instant Security Systems Owner's Manual

LINKING YOUR UNITS WIRELESSLY

You must teach your MAU to respond to the
Keychain remote and detection units. You can do
this easily and quickly by using the "Learn" mode.
Using Learn Mode to Connect Devices
Each LaserShield
identification code that the MAU learns. This
code allows the MAU to respond to and report
on the status of each device. Follow these few
simple steps to connect your devices using
"Learn" mode:
1.
Press the "Learn" button on the rear of the
MAU. The MAU will verbally announce,
"Learn mode."
2.
Next, on each Keychain Remote and WDU,
press the Panic Button to link the unit. The
MAU will announce each unit linked. When
the MAU has announced a unit is linked, you
may move on to the next device.
When you have learned all remote devices into
the MAU, press the "Learn" mode button again.
The MAU will verbally announce the number of
devices linked. Make certain each device is
verbally announced.
If the MAU does not receive
a signal to activate another
Remote Device within 60
seconds, it will exit "Learn Mode"
automatically. A voice prompt will
announce that the MAU is leaving
"Learn Mode".
Note: There may be a brief delay before the
Master Alarm Unit responds to signals from
remote devices.
®
Page 10 LaserShield
® device has a unique
Instant Security System OWNER'S MANUAL