Settings For An Entire Song; Naming A Song (Song Name); Naming A Pattern (Pattern Name) - Roland XP-60 Owner's Manual

Settings for an entire song

You can make settings specific for each song, such as assign-
ing song name or specifying a Locate position. These settings
are saved at the same time you save a song to disk.

Naming a song (Song Name)

You can assign a new name to a song, or modify an existing
name. The song name is separate from the file name. You
don't have to name a song if you don't want to, but since a
song name can have up to 15 characters, you can input a
song title or remarks that help you to organize your songs
later on.
Some commercial SMF data contains copyrighted
information. If you load copyrighted SMF data, an
indication such as "(C) 1996 Roland Corporation" will
be displayed and it will not be possible to modify the
song name.
<Procedure>
Make sure that the Play display (SEQ(Song)) is up.
Move the cursor to the song number and select the
song to which you want to assign a song name.
Press [F1] (Setup).
Press [F1] (SngName) to call up the Song Name dis-
play (SEQ/Setup).
If you have selected a song previously saved to disk in
step 2, a window asks "This Song is not Internal Song.
Load anyway?" If you want to erase the song from
internal memory and load the new song, press [F5]
(OK). If you decide not to erase the song from the
internal memory, press [F6] (Cancel).
Press [l ] or [r ] to move the cursor to the location
where you want to input a character.
Input the desired character using [INC]/[DEC], the
numeric keys or the VALUE dial.
When you are assigning a song name in the Name window,
press [F1] (SngName).
Repeat steps 5 and 6 to assign the song name you
want.
When you finish entering the song name, press [EXIT]
to return to the Play display (SEQ(Song)).
118
[SEQUENCER] [F1] (Setup) [F1] (Sng Name)/[F2] (Ptn Name)
Measure number
Chapter 5. Editing a song

Naming a Pattern (Pattern Name)

You can assign a new name to a Pattern, or modify the exist-
ing name. Up to 15 alphanumeric characters can be specified
for the Pattern name.
<Procedure>
Make sure that the Play display (SEQ(Song)) is up.
Move the cursor to the song number and select the
song to which you want to assign a Pattern name.
Press [F1] (Setup).
Press [F2] (PtnName) to call up the Pattern Name dis-
play (SEQ/Setup).
If you have selected a song previously saved to disk in
step 2, a window asks "This Song is not Internal Song.
Load anyway?" If you want to erase the song from the
internal memory and load the new song, press [F5]
(OK). If you decide not to erase the song from the
internal memory, press [F6] (Cancel).
Press [PATTERN] to open the Pattern Select window
and select the Pattern number.
Press [l ] or [r ] to move the cursor to the location
where you want to input a character.
Input the desired character using [INC]/[DEC], the
numeric keys or the VALUE dial.
When you are assigning a Pattern name in the Name win-
dow, press [F2] (PtnName).
Repeat steps 6 and 7 to assign the Pattern name you
want.
When you finish entering the Pattern name, press
[EXIT] to return to the Play display (SEQ(Pattern)).To
return to the Play display (SEQ(Song)), press [EXIT]
again.
Measure number