Roland XP-60 Owner's Manual page 85

Level (Output level)
Adjust the output level.
28: OVERDRIVE DELAY
This effect connects an overdrive and a delay in series.
L in
Overdrive
R in
OD Drive
Adjust the degree of overdrive distortion. The volume will
change together with the degree of distortion.
OD Pan (Output pan) #
Adjust the stereo location of the overdrive sound. L64 is far
left, 0 is center, and 63R is far right.
Delay Time
Adjust the time delay from when the direct sound begins
until the delay sound is heard.
Delay Feedback (Delay feedback level)
Adjust the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
Delay HF Damp
Adjust the frequency above which delayed sound fed back
to the effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to BYPASS.
Delay Balance #
Adjust the volume balance between the overdrive sound
that is sent through the delay and the overdrive sound that
is not sent through the delay. With a setting of "D100: 0E,"
only the overdrive sound will be output. With a setting of
"D0: 100E," only the overdrive sound that is sent through
the delay will be output.
Level (Output level)
Adjust the output level.
29: DISTORTION CHORUS
This effect connects a distortion and a chorus in series. The
parameters are the same as for "26: OVERDRIVE
RUS."
L in
Distortion
R in
L out
Balance D
Balance W
Delay
Balance W
Feedback
R out
Balance D
L out
Balance D
Balance W
Chorus
Balance W
R out
Balance D
Chapter 3. Creating your own sounds
30: DISTORTION
This effect connects a distortion and a flanger in series. The
parameters are the same as for "27: OVERDRIVE
FLANGER."
L in
Distortion
R in
31: DISTORTION
This effect connects a distortion and a delay in series. The
parameters are the same as for "28: OVERDRIVE
DELAY."
L in
Distortion
R in
32: ENHANCER
This effect connects an enhancer and a chorus in series.
L in
Enhancer
R in
Enhancer
EH Sens (Enhancer Sensitivity) #
Adjust the sensitivity of the enhancer.
EH Mix (Enhancer Mix level)
Adjust the ratio with which the overtones generated by the
enhancer are combined with the direct sound.
Chorus Pre Delay (Chorus pre delay time)
Adjust the time delay from when the direct sound begins
until the chorus sound is heard.
Chorus Rate
CHO-
Adjust the modulation speed of the chorus effect.
Chorus Depth
Adjust the modulation depth of the chorus effect.
Chorus Balance #
Adjust the volume balance between the enhancer sound that
is sent through the chorus and the enhancer sound that is
not sent through the chorus. With a setting of "D100: 0E,"
only the enhancer sound will be output. With a setting of
"D0: 100E," only the enhancer sound that is sent through the
chorus will be output.
Level (Output level)
Adjust the output level.
FLANGER
Balance D
Feedback
Balance W
Flanger
Balance W
Balance D
DELAY
Balance D
Balance W
Delay
Balance W
Feedback
Balance D
CHORUS
Balance D
Mix
Chorus
Balance D
Mix
L out
R out
L out
R out
L out
Balance W
Balance W
R out
85