Serial Output Units; Serial Output Setup - GE Optica Operator's Manual

Serial Output Units

Setting
Humidity Units*
Temperature Units*
Pressure Units*
User Units*
*Note: The TAB key selects or deselects the desired output units. If selected, the number of decimals can
be set using a keypad entry (0-6).

Serial Output Setup

Setting
Format
Field Separator
Record Terminator
Interval in seconds
Show Status*
Time Stamp
Programming the 4x40 Optica
Table 5-4: Serial Output Unit Options
Description
Set the units for humidity.
Set the units for temperature.
Set the units for pressure.
Set the selected user equation.
Table 5-5: Serial Output Setup Options
Description
Choose the output format for the
selected parameter.
Choose the separator to be used
between parameters.
Choose the terminator(s) for each
group of data.
Enter the output interval in seconds
(for Serial Mode: All).
Output dew point sensor status with
each data string (Heat, Cool, Balance,
PACER, Service, Alarm 1, Alarm2).
Output date and time with each data
string.
Available Options
See Table 4-1 on page 4-4 for the
parameter chosen.
See Table 4-1 on page 4-4 for the
parameter chosen.
See Table 4-1 on page 4-4 for the
parameter chosen.
Choose from any available User
Equation.
Available Options
For humidity, e.g., Dp=##.#, ###.#(Dp),
No Prompt
Space, Comma, Tab, CR, CR-LF
Comma, CR, CR-LF
Enter a number.
Enabled/Disabled
Enabled/Disabled
January 2006
5-5