Mark top dead center
Oil filter wrench
In the position at
which the filter
gasket first contacts
the mounting
surface.
Tighten the filter 2 turns or
to specified torque.
9. Mark the top dead center position on the
"cap type" filter wrench or on the oil filter.
Use an oil filter wrench to tighten the fil-
ter 2 turns or to specified torque.
Oil filter tightening torque:
20 N·m (2.0 kgf-m, 14.5 lbf-ft)
10. Replace the drain plug gasket 3 with a
new one. Reinstall the drain plug 2 and
gasket 3. Tighten the plug securely with
a torque wrench. Pour about 3200 ml
(3.4/2.8 US/Imp qt) of the specified oil in
the filler hole. Tighten the oil filler cap.
Start the engine and allow it to idle for
three minutes.
Drain plug tightening torque:
23 N·m (2.3 kgf-m, 16.5 lbf-ft)
NOTE: About 3000 ml (3.2/2.6 US/Imp qt) of
oil will be required when changing oil only.
6-37