Installation; Mounting The Outboard Motor On Boat - TOHATSU MFS2.5B Original Instructions Manual

MFS2-25-35B_EUR_EN_141218N.book 18 ページ ２０１４年１２月１８日 木曜日 午後７時１２分
18

INSTALLATION

ENOM00024-B
1. Mounting the outboard motor on
boat
ENOW00006-0
WARNING
Most boats are rated and certified in terms
of their maximum allowable horsepower,
as shown on the boat's certification plate.
Do not equip your boat with an outboard
motor that exceeds this limit. If in doubt,
contact your dealer.
Do not operate the outboard motor until it
5
has been securely mounted on the boat in
accordance with the instructions below.
ENOW00009-0
WARNING
 Mounting the outboard motor without
following this manual can lead to unsafe
conditions such as poor maneuverabil-
ity, lack of control or fire.
 Loose clamp screws and/or mounting
bolts can lead to the release or displace-
ment of the outboard motor, possibly
resulting in lost of control and/or serious
personal injury. Be sure that fasteners
are tightened to the specified torque (30
Nm (3.0 kgf) 13 ft-lb). Check the fasten-
ers for tightness from time to time.
 Be sure to use outboard mounting fas-
teners included in the outboard motor
package or their equivalents in terms of
size, material, quality and strength.
Tighten fasteners to the specified torque
(30 Nm (3.0 kgf) 13 ft-lb). Test cruise to
c h e c k i f f a s t e n e r s a r e t i g h t e n e d
securely.
 Outboard motor mounting must be per-
formed by trained service person(s)
using lift or hoist with sufficient capacity.
Keep the outboard motor in a vertical posi-
tion when mounting.
ENOM00025-0
Position ... Above keel line
Set engine at center of boat.
1
1. Center of boat
2. Boat transom
ENOM00026-0
Transom matching
Be sure that the anti ventilation plate of the
outboard motor is 30–50 mm (1.2–2 in)
below the bottom of hull.
If the above condition cannot be met due
to the shape of the bottom of your boat,
please consult your authorized dealer.
ENOF01607-0
2
ENOF01141-0