Warming Up The Engine - TOHATSU MFS2.5B Original Instructions Manual

MFS2-25-35B_EUR_EN_141218N.book 27 ページ ２０１４年１２月１８日 木曜日 午後７時１２分
4. Remove the recoil starter.
5. Tighten the three bolts (A, B, C) fas-
tening the tank and one bolt (D) fasten-
ing the recoil starter.
D
6. Insert the knotted end of the starter
rope into the notch in the flywheel and
wind the rope around the flywheel sev-
eral turns clockwise.
7. Tie a loop in the another end of the
emergency starter rope and attach
socket wrench that is included in the
tool kit.
8. Set the control lever in the Neutral
9. Pull the starter handle slowly until you
ENOF00220 0
A
10. After engine starts, do not reinstall fly-
ENOM00043-B
B
C

3. Warming up the engine

ENOF00221-0
ENOW00932-0
Be sure to check that cooling water is
coming out of the cooling water check port
during warm up.
Warm the engine at low engine speeds for
about
3 minutes : above 41°F (5 ℃ )
5 minutes at 2000 rpm : below 41°F (5 ℃ )
This allows the lubricating oil to circulate to
all parts of the engine. Operating the
ENOF01610-0
engine without warm up shortens the
engine's life.
ENGINE OPERATION
position.
feel engagement, keep pulling till you
feel less resistance. Then pull it quickly.
wheel cover and top cowl.
CAUTION
27
ENOF00222 0
7