Burner Ignition; Lighting With Snap-Jet ™ Gas Ignition System - Weber Summit Series Owner's Manual

BURNER IGNITION - Lighting with Snap-Jet
METHODS OF BURNER IGNITION
There are two ways to ignite the burner. The first
is by using the Snap-Jet gas ignition system built
™
into the burner control knob on your grill. The
second is with a match.
Next are the steps for igniting your grill using the
Snap-Jet gas ignition system. On the follow page
™
are steps for igniting your grill with a match.
Summarized lighting instructions are also located
on the ignition box.
Burner Ignition –
Lighting with Snap-Jet
™
System
1. Rotate the Rapidfire lid damper to the open
™
position (A).
2. Slide the bowl vent arm to the open position (B).
3. Maker sure that the burner control knob is
turned to the OFF ( ) position (C). Check by
pushing burner control knob in and turning it
clockwise until it stops.
4. Confirm that the cylinder is properly installed.
Refer to "INSTALLING THE LP CYLINDER."
5. Open the grill lid (D).
m DANGER
Failure to open the lid before igniting the
grill's burner, or not waiting five minutes
to allow the gas to clear if the grill does
not light, may result in an explosive flare-
up which can cause serious bodily injury
or death.
6. Position the charcoal on the fuel grate. Refer to
the "GRILLING METHODS" sections for proper
fuel grate placement and charcoal placement.
7. Push burner control knob in and turn it slowly
counterclockwise to the on ( ) position (E). You
will hear the igniter click. Repeat until burner
ignites.
8. Check that the burner is lit by observing
a flame.
m WARNING: If burner fails to ignite
within five seconds, stop, turn the
burner control knob to off, and wait five
minutes to allow the gas to clear before
you try again or light with a match.
m WARNING: Do not lean over the open
grill while igniting.
m CAUTION: Flame may be hard to see on
a bright day.
9. Turn the burner control knob to the the OFF ( )
position after 12-14 minutes if cooking directly
or indirectly. However, if smoking, turn the
burner control knob to the the OFF ( ) position
after 7-10 minutes.
NOTE: The burner is only meant for igniting charcoal,
not for cooking. Turn burner control knob off promptly
after charcoal is lit to preserve the fuel in your
disposable cylinder.
26
A
Gas Ignition
C
Gas Ignition System
™
B
D
E