Download Print this page

Delete Detectors; Intelligent Accessories; Code Match Between Host & Wireless Strobe Siren; Code Match Between Host And Smart Socket - KERUI G18 User Manual

Gsm alarm system
Hide thumbs

Advertisement

Table of Contents

3.7.4 Delete Detectors

As shown in picture 3-2, press key【4. Delete Detectors】. With the voice prompt "
Please input numbers (01-99)"( e.g. delete Zone No. 1 remote control, then input
01; delete Zone No. 22 remote control, input 22; delete all by pressing key 【ARM
】 then press key【OK】.
),

3.7.5 Intelligent Accessories

As shown in picture 3-2, press key【1. Add Remote Controls】. With the voice
prompt "Please input numbers:"( 0 means siren, 9 means alarm relay), then press
key【Arm】 and host sends open signals; press key【Disarm】and host sends
close signals.
3.7.5.1 Code Match between Host & Wireless Strobe Siren
Code Match Method:
In strobe siren standby mode, long press key SET until the
alarm indicator lit constantly to enter learning state; Then on intelligent accessories
page, input No. 0, press key【ARM】or【DISARM】, host will send signal as shown
in picture 3-2; wireless strobe siren will beep twice and indicator flashes twice
after receiving the signal, which means the code match successfully, then press
the SET key of strobe siren to exit the learning state.
Check the Success of Code Match:
press key【ARM】or【DISARM】 to switch【Wireless Strobe Siren】ON or OFF, if it 's
OFF, strobe siren will beep "di di"; if it 's ON, siren will alarm siren, which means
the host match code successfully with wireless strobe siren.
Siren J009
after wireless strobe siren exit learning state,
Solar Strobe Siren J1

3.7.5.2 Code Match between Host and Smart Socket

Code Match Method:
In smart socket standby mode, long press key SET for 5s
until the socket indicator light turns out to enter learning state; Then on intelligent
accessories page, press key 【ARM】or【DISARM】 to switch smart socket ON or
OFF, host will send signal ; smart socket indicator light flashes twice, which means
the code match successfully, then press the SET key of smart socket to exit the
learning state.
Check the Success of Code Match:
key【ARM】or【DISARM】 to switch smart socket ON or OFF, if it's OFF, smart socket
lit RED; if it 's ON, socket lit BLUE, which means the host match code successfully
with smart socket.
Mart Socket S71

3.8 System Set

On main page, press key【UP/DOWN】to move the cursor behind【System Set】,
then press key【OK】or number 3 to enter system set page, as shown in picture 3-3.

3.8.1 Delay Set

On system set page, put cursor on 【Delay Set】, and press key【OK】or number
1 to enter delay set page, as shown in picture 3-3.

3.8.1.1 Delay Arm Set

On delay set page, put cursor on【Delay Arm Time】, input the delay time(00-99s),
00 means without delay, arming immediately, then press key【OK】to save setting,
as shown in picture 3-4.

3.8.1.2 Delay Alarm Set

On delay set page, press key【DOWN】to move cursor behind【Delay Alarm Time】 ,
input the delay period(00-99s), 00 means without delay, alarming immediately,
then press key【OK】to save the setting.
after smart socket exit learning state, press

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for KERUI G18

  Related Content for KERUI G18