Suzuki 125 Service Manual page 60

Step 1 (When indicating P0115-L:)
1) Turn the ignition switch OFF.
2) Check the ET sensor coupler 1 for loose or poor contacts.
If OK, then measure the output voltage.
3) Disconnect the ET sensor coupler.
4) Check the continuity between O wire A and ground.
If the sound is not heard from the tester, the circuit condition
is OK.
 Tester knob indication: Continuity test ()
Are the continuity and voltage OK?
YES Go to Step 2.
• O wire shorted to ground
NO
• If wire is OK, go to Step 2.
5) After repairing the trouble, clear the DTC using SDS tool.
(Page 40)
RV125K7 ('07-MODEL) 59
1
1