Suzuki 125 Service Manual page 93

92 RV125K7 ('07-MODEL)
• Install the injector as shown.

Never turn the injector while pushing it.
• Install the O-rings 2 and 3.

Replace the O-rings with new ones.
• Install the insulator.
NOTE:
Set the insulator so the O-ring faces to the engine side and tab
A upward.
• Install the throttle body.
• Connect the throttle pulling cable 4 and throttle returning
cable 5 to the throttle cable drum.
• Loosen each throttle cable lock-nut.
• Turn in each throttle cable adjuster fully and locate each outer
cable so that the clearance is 0 mm.
• Tighten each lock-nut.
• Adjust the throttle cable play. ( Page 7)
• Rout the harness and fuel hoses properly.
( Page 94 and 95)
0 mm
22.5˚ 22.5˚
0 mm