Advertisement
2A.14
Air-cooled two-stroke engine
14.29b Installing the crankshaft with the
Peugeot service tools
14.29~ Installing the crankshaft with the
home-made tool
L ;
: :
: :
. q g
TOGETHER
WASHER
Nz~Y
WELD
M I 0
x
1.25mm
PITCH NUT
THREADED
40mm DIAMETER
H32761
ROD
STEEL TUBE
14.29d Details of the home-made tool for installing the crankshaft
two-stroke oil, then, if the main bearing is in the
crankcase half, pull the crank assembly into
place ensuring the connecting rod is aligned
with the crankcase mouth. Peugeot produce
five individual service tools (Pt. Nos.
752168,
64706, 750069, 64710
and
69104)
to do this
(see illustration). Alternatively, use the set-up
shown (see illustrations). If the main bearing is
on the crankshaft, heat the bearing housing in
the crankcase with a hot air gun before fitting
the crank assembly (see illustration). Note:
Avoid applying direct heat onto the crankshaft
14.29e Heating the crankcase with a hot
oil seal.
air gun
30 Wipe the mating surfaces of both
crankcase halves with a rag soaked in a
suitable solvent and fit the dowels and new
gasket to the left-hand half (see illustration).
31 Now fit the right-hand crankcase half.
Lubricate the shaft, seal and bearing with the
specified two-stroke oil, then, if the main
bearing is in the crankcase half, press the
crankcase half into place. Peugeot produce
five individual service tools (Pt. Nos.
750808,
64706, 750069, 64710
and
69104)
to do this
(see illustration). Alternatively, place a thick
washer over the centre of the crankcase to
14.30 Install the crankcase dowels (A) and gasket (B)
14.31 Installing the right-hand crankcase half with the Peugeot
service tools
Advertisement
