Advertisement
7.2 Bodywork
3.1 On Speedfight models, undo the
screws (arrowed) and remove the cover
3.2 Undo the nut to remove the footrest
4.1 Turn the lock to release the seat
catch (A)
unclip the cable from the back of the panel
and the lock (see illustrations), then remove
the body panel (see Section 6).
4 The lock is retained in a recess in the panel
by a spring clip. Pull off the spring clip, note
how the lock locates in the panel recess, then
remove the lock (see illustration).
5 Check the operation of the latch mech-
anism and lubricate it with a smear of grease.
6 Installation is the reverse of removal.
A
Warning: Ensure the actuating
rod or cable is
property
connected
to the lock before closing the
seat, otherwise you will have no way o f
releasing the latch.
Removal
4 Seat and storage
compartment
-
removal and installation
1 On Speedfight models, undo the two
screws that retain the footrest cover and
remove the cover (see illustration).
2 On all models, counterhold the footrest
pivot bolt and undo the nut on the underside
of the footrest, then remove the nut and plain
washer (see illustration).
3 Withdraw the bolt and spring washer from
the footrest bracket and slide the footrest out
of the bracket. Note the bush inside the
footrest pivot hole.
Seat
1 To remove the seat, insert the ignition key
into the seat lock and turn it anti-clockwise.
This will release the catch on the rear
underside of the seat base (see illustration).
Swing the seat upright.
2 The seat is retained by the hinge at the front of
the seat base (see illustration). Support the seat
and undo the hinge bolts, then
lift
the seat away.
3 The seat latch mechanism is actuated
either by a rod or cable from the seat lock
(see Illustrations). To remove the seat lock,
first remove the storage compartment (see
Steps 7 to 11). Unclip the rod from the lock or
lnstallation
4 Installation is the reverse of removal. Apply
a smear of grease to the pivot bolt and ensure
the spring washer is fitted on the bolt before it
is installed. Tighten the nut enough to allow
the footrest to pivot without binding in the
bracket.
Storage compartment
7 Unlock the seat and swing it upright. An
engine access panel is fitted in the bottom of
the compartment. To open the panel, unclip
I
I
4.3b
. . .
or by cable
4.3a Latch mechanism is actuated either
byrod
...
4.2 Undo the hinge bolts to remove the
seat
4 . 3 ~ Unclip the cable from the stop on the
4.3d
. . .
then from the back of the lock
4.4 Pull off the clip to remove the lock
panel..
.
Advertisement
